VSS KB Articles

How to Configure DNS on a Domain Controller with Two IP Addresses
7/12/2018
How to Configure DNS on a Domain Controller with Two IP Addresses; Configure DNS on a DC with two IP addresses


How to safeguard from the SWEET32
7/12/2018
How to safeguard from the SWEET32 Issue, CVE-2016-2183, Disable RC4 and 3DES on Windows Server


Redirect from HTTP to HTTPS using the IIS URL Rewrite module
2/12/2018
This is the most common requirement on most of the Exchange servers hosted on IIS. The server admins configure an http to https redirect.


Sonicwall disconnects from network every 10-15 minutes on Verizon FIOS
2/11/2018
ISP temporarily disabling port due to receiving excessive ARP requests from SonicWall. Here are the settings to resolve it.


Encrypting Connections to MS SQL Server
2/8/2018
If you want to use encryption with a failover cluster, you must install the server certificate with the fully qualified DNS name of the failover clustered instance on all nodes in the failover cluster. For example, if you have a two-node cluster...


    

8/29/2017
How to disable default gateway in windows 8 to 10

To change the Use default gateway on remote network settings for IPv6 and for IPv4, follow these steps:

  1. Press the Windows logo key+R to open the Run box.
  2. Type ncpa.cpl in the Run box, and then press Enter to open Network Connections.
  3. Right-click the VPN connection, and then click Properties.
  4. Click the Networking tab in the VPN connection properties dialog box, select Internet Protocol Version 6 (TCP/IPv6), and then click Properties.
  5. Click Advanced… in the Protocol properties box.
  6. Click the IP Settings tab in the Advanced TCP/IP Settings box.
  7. To disable the default gateway, clear the Use default gateway on remote network check box. Or, to enable the default gateway, select the Use default gateway on remote network check box.
  8. Click OK to close the Advanced TCP/IP Settings dialog box.
  9. Click OK to close the Protocol properties dialog box.
  10. Select Internet Protocol Version 4 (TCP/IPv4), click Properties, and then repeat step 5 through step 9 to change the default gateway setting for IPv4.
  11. Click OK to close the VPN connection properties dialog box.
Note By default, the Use default gateway on remote network check box is selected.